Today LED technology is replacing the technology of old traditional lights. If you are also planning to replace traditional fluorescent bulbs with LED tube lights on your own then here are some important tips, which will be helpful for you in this regard, and you will be able to replace traditional lighting system of your home with LED lights. Today LED tube lights are becoming forefront of the lighting system in any home, which was normally of traditional lights like Cf Ls and fluorescent tube lights. LED lights have very low luminous intensity. Therefore, these lights distribute light in all directions more than normal and traditional lights. The intensity of glare of these lights is also lower than normal traditional lights. These light are durable and consume less energy therefore, they are best as a cost efficient because these lights save electricity bills as well as the cost of replacement of lights after some time. LED lights work son green technology, which means that these lights create less harmful elements like toxic mercury.There is also no need to change your complete electrical wiring system because with just simple modification you can install these lights.Therefore, if you are planning to change lighting system of your home must consider LED tube lights as your new lighting system. Here are some simple ways through which you can install these lights. • When you are replacing your old traditional lighting system with LED tube lights you will see that there are three main components, which are starter, ballast, and tube light, you have to get rid of all these three components. You will see that starter is not a separate component as most of the time it is built in ballast. • Remove old tube lights and bulbs from the fixture and when you are doing so make sure that main switch or supply of electricity is off. During all this process, you need some simple tools like wires, cutter, screwdrivers, wire stripper, some bolts, and nuts, so keep these tools with you when you are going through this process.• When you have removed old traditional tube light or bulb now remove that reflector which is enclosing wire and ballast. It is simple and easy to remove, if it has screw then you can remove it with the help of screwdriver otherwise simply pull it with the help of wire stripper. • Now remove ballast and starter if it is separate then ballast. Ballast has two screws holding it, simply with the help of a screw drive run screw them and remove it from the fixture. During this process, wires may also remove so connect them in the fixture to complete the circuit. • You have almost completed the task now fix the reflector to is place din the fixture and insert LED lights in the sockets. Make sure that you are inserting LED lights from top to bottom ends and if you are unable to indent if both ends, take help from the manual which manufacturer provides with LED tube lights.